 |
|
|
|
|
|
|
|
|
|
|
|
 |
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
|
||||
 |
 |
 |
|
||||||||
 |
 |
 |
 |
 |
|
||||||
 |
 |
|
|||||||||
 |
 |
 |
 |
 |
|
||||||
 |
 |
 |
|
||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| RENDER
FINISHES |
 BRICK EFFECT RENDER |
 DRY DASH FINISH |
||
|
Two
or three coat brick effect render, used to simulate the appearance of
brickwork. A coloured mortar coat is trowel applied and the top coat is
applied in a contrasting colour whilst still soft. This is then carefully
set out and cut back using a specialist cutting tool.
|
A
coloured render coated with a spar dash finish. A wide range of aggregates
in various colours can be used to dash the surface, which is applied at
8mm whilst the render is still soft.
|
|
|
 ALPINE FINISH |
 ACRYLIC FINISH |
||
|
A
base coat render is applied at a minimum thickness of 8mm. This is ruled
to provide a flat surface. Alpine render is then applied at 2-4mm and
spread flat in a single direction which gives it a scored texture.
|
A
base coat render is applied at a minimum thickness of 8mm. This is ruled
to provide a flat surface. A primer coat is then applied followed by an
acrylic finish at 1-2mm.
|
|
|
|
SCRATCH RENDER |
|||
|
This
product is applied over a base coat render at approximately 10mm thickness.
The surface is then scratched back using a nail float resulting in a textured
finish.
|
|
|
Company
Profile | External
Wall Insulation |
Render
Finishes | Structural
Systems
Should you experience any problems with this site, please contact our webmaster © Skyline Construction Services Limited 2002-2003. All Rights Reserved. |